Removing The Sas Raid Card Holder; Concluding Steps - Fujitsu PRIMERGY RX2520 M1 Upgrade And Maintenance Manual

Ê Loosen the screw on the RAID card holder (1).
Ê Carefully pull up on the SAS RAID controller in a vertical motion and remove
it from its slot (2).
9.4.2.3

Removing the SAS RAID card holder

Figure 92: Removing the RAID card holder
Ê Remove the screws(1).
Ê Remove the slot bracket (2).
9.4.2.4

Concluding steps

"Reassembling" on page 59
Ê
"Connecting the server to the power source" on page 64
Ê
"Switching on the server" on page 66
Ê
Ê In order to configure an expansion card that has been installed or replaced,
the card's Option ROM has to be enabled in the system board BIOS. If
applicable, proceed as described in section
page 80.
"Enabling SVOM boot watchdog functionality" on page 87
Ê
"Enabling BitLocker functionality" on page 93
Ê
"Updating RAID controller firmware" on page 79
Ê
RX2520 M1
Upgrade and Maintenance Manual
Expansion cards and backup units
"Enabling Option ROM scan" on
195