Sas Raid Controller In Pci Slot 10; Installing The Sas Raid Controller; Required Tools; Preliminary Steps - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

9.5

SAS RAID controller in PCI slot 10

9.5.1

Installing the SAS RAID controller

Upgrade and Repair Units (URU)
Average hardware task duration: 10 minutes
Average software task duration: 5 minutes
9.5.1.1

Required tools

Preliminary and concluding steps: tool-less
●
Installing the SAS RAID controller:
●
– Phillips PH2 / (+) No. 2 screw driver
Mounting slot brackets:
●
– Phillips PH2 / (+) No. 2 screw driver
9.5.1.2

Preliminary steps

Before installing the SAS RAID controller, perform the following steps:
Ê Disable BitLocker functionality as described in section
functionality" on page
Ê Disable boot watchdog functionality as described in section
SVOM boot watchdog functionality" on page
Ê Shut down the server as described in section
page 67.
Ê Remove the AC power cords from the PSU cable brackets and disconnect
them from the system as described in section
from the mains" on page
TX300 S7 / RX350 S7
133.
68.
Upgrade and Maintenance Manual
Expansion cards and backup units
"Disabling BitLocker
134.
"Shutting down the server" on
"Disconnecting the server
"Disabling
475