Table of Contents
Advertisement
6.4
Replacing a hot-plug power supply unit
Customer Replaceable Unit
(CRU)
Tools: tool-less
V
CAUTION!
When replacing a power supply unit in a non-redundant power supply
●
configuration, the server must be switched off first.
Replace the power supply unit after specifying the one that breaks
●
down at work by revitalization.
Ensure to replace a defective power supply unit by a new unit of the
●
same type.
6.4.1
Preliminary steps
"Locating the defective server" on page 49
Ê
"Locating the defective component" on page 51
Ê
Ê In non-redundant power supply configurations, shut down the server as
described in section
"Disconnecting power cords" on page 52
Ê
6.4.2
Removing the defective hot-plug power supply
unit
Ê Remove the defective power supply unit as described in section
a hot-plug power supply unit" on page
RX2520 M1
"Shutting down the server" on page
Upgrade and Maintenance Manual
Power supply units
Hardware: 5 minutes
107.
51.
"Removing
109
Advertisement
Table of Contents
