Basic hardware procedures
Figure 8: Installing the air duct
Ê Insert the air duct first with the rear side (1).
Ê Fold down the air duct (2).
I
If there is a FBU installed, follow the procedure that is described in
section
4.5.2
Closing the server
V
CAUTION!
Before attaching the covers, make sure no unnecessary parts or tools
●
are left inside the server.
In order to comply with applicable EMC regulations (regulations on
●
electromagnetic compatibility) and satisfy cooling requirements, the
PRIMERGY RX2520 M1 server must not run while the housing cover
is removed.
For further safety information, please refer to chapter
●
information" on page
60
"Installing the air duct with an FBU" on page
37.
Upgrade and Maintenance Manual
205.
"Important
RX2520 M1