Hard disk drives / solid state drives
7.3.3.3
Installing a 3.5-inch dummy module
V
CAUTION!
If the removed HDD module is not replaced immediately, always replace
a dummy module into the unused HDD bay to comply with applicable
EMC regulations and satisfy cooling requirements.
Figure 47: Installing a 3.5-inch dummy module
Ê Slide the 3.5-inch dummy module into the drive bay until it locks in place.
7.3.3.4
Concluding steps
"Performing a RAID array rebuild" on page 94
Ê
7.3.4
Replacing a 3.5-inch HDD module
Customer Replaceable Unit
(CRU)
Tools: tool-less
140
Upgrade and Maintenance Manual
Hardware: 5 minutes
RX2520 M1