Sas Raid Controller; Installing A Sas Raid Controller - Fujitsu PRIMERGY BX920 S2 Options Manual

8

SAS RAID Controller

V
CAUTION!
Please note the safety instructions in
page 15.
8.1

Installing a SAS RAID controller

To control the two hard disk drives (HDD) of the server blade, you can install a
SAS RAID mezzanine card instead of mezzanine card #2. This is connected via
cable to a special HDD backplane, which also has to be installed.
The following photo shows the parts you need for the installation:
Figure 26: Parts needed for the installation
1 SAS cable #1 for the SAS0 connector (red)
2 SAS cable #2 for the SAS1 connector (gray)
3 SGPIO cable
4 SAS RAID mezzanine card D3016
5 iBBU08 with 3 screws (optional)
6 Heat sink for the IOH
7 HDD backplane
BX920 S2
chapter "Safety instructions" on
Options Guide 49