Ê Fasten the tape drive dummy module with 2 screws.
Ê Insert the drive cage into bay 2, for further information see sectjon
the RDX drive" on page
Ê Insert the HDD cage into bay 1, for further information see sectjon
a HDD cage" on page
Ê If applicable, remove the USB 3.0 interface card as describe in section
"Removing an expansion card" on page 189
12.8.4 Concluding steps
"Installing the fan box" on page 171
Ê
"Reassembling" on page 59
Ê
"Connecting the server to the power source" on page 64
Ê
"Switching on the server" on page 66
Ê
"Verifying and configuring the backup software solution" on page 81
Ê
"Enabling BitLocker functionality" on page 93
Ê
12.9
Replacing the RDX drive in 2.5-inch version
Upgrade and Repair Unit
(URU)
Tools: Phillips PH2 / (+) No. 2 screw driver
12.9.1 Preliminary steps
"Disabling or suspending BitLocker functionality" on page 67
Ê
"Locating the defective server" on page 49
Ê
"Removing backup and optical disk media" on page 71
Ê
"Verifying and configuring the backup software solution" on page 71
Ê
"Shutting down the server" on page 51
Ê
RX2520 M1
286.
159.
Upgrade and Maintenance Manual
Accessible drives
Hardware: 10 minutes
"Installing
"Installing
293