11.2
Installing processors
Upgrade and Repair Unit
(URU)
Tool:
Phillips PH2 / (+) No. 2 screw driver
V
CAUTION!
Processors are extremely sensitive to electrostatic discharge and must
be handled with care. After a processor has been removed from its
protective sleeve or from its socket, place it upside down on a
nonconducting, antistatic surface. Never push a processor over a
surface.
11.2.1 Preliminary steps
"Disabling or suspending BitLocker functionality" on page 67
Ê
"Disabling SVOM boot watchdog functionality" on page 68
Ê
"Shutting down the server" on page 51
Ê
"Disconnecting power cords" on page 52
Ê
"Getting access to the component" on page
Ê
11.2.2 Installing the processor
I
This description applies to the following procedures:
– Installing the second CPU in a mono-processor configuration
– Transfering a CPU after replacing the system board (see section
"Swapping processors" on page
RX2520 M1
Upgrade and Maintenance Manual
Hardware: 15 minutes
Software: 5 minutes
53.c
370)
Processors
233