Installing The Heat Sink - Fujitsu PRIMERGY RX2520 M1 Upgrade And Maintenance Manual

Hide thumbs Also See for PRIMERGY RX2520 M1:

Table of Contents

11.5.2.2 Installing the heat sink

Figure 136: Installing the heat sink

Ê Align the heat sink with the uncovered copper heat pipes (H, see above)

facing towards the PSU.

Ê Carefully seat the heat sink on the four threaded holes as shown (see close-

– Ensure that the screws on the heat sink are properly seated on the

threaded holes.

– Ensure that the heat sink cooling fins match the direction of the

Ê Fasten the four captive screws on the heat sink in a crossover pattern

(screw torque: 1.0 Nm, not applicable for the Japanese market) (1-4).

Upgrade and Maintenance Manual