Table of Contents
Advertisement
Removing processors from the defective system board
Ê Carefully remove the processors from their sockets on the defective system
board as described in
V
CAUTION!
Remove and reinstall one processor at a time. Do not remove the
second processor from the defective system board until the first
processor has been installed on the new system board.
Installing processors on the new system board
"Installing the processor" on page
Ê
Installing protective socket covers on the defective system board
I
Since the defective system board is sent back for repair, protect the
delicate processor socket springs with a socket cover.
"Removing the protective cover" on page 234
Ê
14.6.4 Concluding steps
Ê Reconnect all cables to the system board. For a complete cabling overview,
please refer to section
Ê Reinstall all remaining system board components as shown in the related
sections:
– SAS RAID controller: see section
page 191
– onboard SAS enabling key: see section
enabling key" on page 358
– Heat sinks: see section
– Memory modules: see section
page 225
I
Install all memory modules into their original slots.
– Expansion cards: see section
I
Install all expansion cards into their original slots.
RX2520 M1
"Removing a processor" on page
233.
"List of used cables" on page
"Installing processor heat sinks" on page 245
"Installing a memory module" on
"Installing expansion cards" on page 183
Upgrade and Maintenance Manual
System board and components
393.
"Installing the SAS RAID controller" on
"Installing the onboard SAS
238.
371
Advertisement
Table of Contents
