Table of Contents
Advertisement
System board and components
– UFM: install the UFM spacer to the system board and install the UFM see
section
"Installing the UFM" on page 337
– TPM (if applicable): see section
"Installing the power backplane" on page 116
Ê
"Installing the fan box" on page 171
Ê
"Reassembling" on page 59
Ê
Ê If applicable, activate TPM functionality in the system BIOS under Security >
TPM (Security Chip) Setting > Security Chip. For more information, refer to the
corresponding BIOS Setup Utility Reference Manual.
Ê Reconnect all external cables.
"Connecting the server to the power source" on page 64
Ê
"Updating or recovering the system board BIOS and iRMC" on page 75
Ê
"Verifying system information backup / restore" on page 77
Ê
"Verifying the system time settings" on page 89
Ê
Ê Inform the customer about changed WWN and MAC addresses. For further
information, refer to section
on page
94.
Ê After replacing the system board in a server running Linux OS,
NIC configuration file in a Linux environment" on page 91
"Enabling SVOM boot watchdog functionality" on page 87
Ê
"Enabling BitLocker functionality" on page 93
Ê
Ê Reconfigure your network settings in the operation system according to the
original configuration of the replaced controller (expansion card or onboard).
I
Configuration of network settings should be performed by the
customer.
For further information, please refer to section
settings recovery" on page
Ê If applicable,
"After replacing the system board" on page
372
"Installing the TPM" on page 346
"Looking up changed MAC / WWN addresses"
364.
Upgrade and Maintenance Manual
"Updating the
"Note on network
98.
RX2520 M1
Advertisement
Table of Contents
