Hard disk drives / solid state drives
7.3.2
Installing 3.5-inch HDD modules
Customer Replaceable Unit
(CRU)
Tools: tool-less
7.3.2.1
Preliminary steps
Ê Locate the correct drive bay as described in section
configurations" on page
7.3.2.2
Removing a 3.5-inch dummy module
Figure 43: Removing a 3.5-inch dummy module
I
Dummy modules have been installed into unused HDD bays. Before
installing an additional HDD, the dummy module needs to be removed
from the desired drive bay.
Ê Press in on the locking tabs on both sides of the dummy module to
disengage the locking mechanism (1).
Ê While keeping the locking tabs pressed, pull the dummy module out of its
bay (2).
136
133.
Upgrade and Maintenance Manual
Hardware: 5 minutes
"3.5-inch HDD / SSD
RX2520 M1