Honda SXS700M4 Service Manual page 483

Pivot the caliper body [1) over the pads and bracket.
Temporarily install the slide pin bolt (2).
INSTALLATION
Install the brake caliper [1] wilh new mounting bolts [2]
and tighten them.
TORQUE : 30 N·m (3.1 kgf' m, 22 IbHt)
If the brake caliper was disassembled, tighten the slide
pin bolt
131.
TORQUE : 32 N' m (3.3 kgf' m, 24 IbHt)
Connect the brake hose
[1)
to the brake caliper with the
oil bolt [2) and new sealing washers
[3J,
and tighten the
oil bolt.
TORQUE : 34 N'm (3.S kgf' m , 25 IbHt)
Install the
pa~ing
brake cable 111 into the caliper body
(2) and connect It to the brake arm [3] with the joint pin
141-
Install the adjuSling nut [51.
Fill and bleed the hydraulic system (page 20-6).
Adjust the par1<ing brake lever freeplay (page 3-17).
Install the right rear wheel (page 19-6).
BRAKE SYSTEM
121
20-25