Honda SXS700M4 Service Manual page 326

DRIVETRAIN SYSTEM
16-38
Apply grease to the lips of a new oil seal [1] , and install
it into the crankcase cover until it is fully seated.
Coat new O-rings [1] wi th engine oil and install them
onto the joint pipes [2).
Install the joint pipes into the oil pump.
Apply liquid sealant (Threebond T81 215 or equivalent)
to the mating surface of the fronl crankcase cover as
shown.
Blow the oil orifice with compressed air to clean the
passage.
Coal new O-rings [1] with engine oil and inslall them
into the orifice (2) grooves.
Install the oil orifice with the small end facing oui.