Honda SXS700M4 Service Manual page 437

Install the breaker arm assembly
(1J
over the center
shaft and adjust the upper rim supports 121 to fit the
outside rim diameter.
Install the lop hold down nul [3) and tighten it finger
light.
WHEEUSUSPENSION
Failure
10
back out
Pull the leverage bar
[11
down so the breaker shoe [2] is
~=================::;
the breakershoe
just below the rim lip. Turn the crank [3] to fully push the
two
turns
will
cause
breaker shoe between the tire bead and rim. Once the
the shoe
10
scratch
shoe contacts the rim, back the crank out two turns to
Ihe bead lock,
allow Ihe shoe to clear the rim's bead lock.
which may cause
the
fire to
/eak.
131
11)
121
Push down on the leverage bar [1) to push the tire bead
~=============::-===::;I
over the bead lock. Use only short strokes on the
wheel as far as it will go between strokes as you break
handle . While the shoe [21 is still engaged , turn the
1
_ - - - - - - 1
1
1
the bead around the rim.
Remove the breaker arm assembly and Hip the wheel
over. Install the breaker arm assembly, adjust the shoe
properly and break the other bead by following the
above procedures.
Remove the lire from the rim using a lire changing
machine or tire irons and rim protectors.
19-7