Honda SXS700M4 Service Manual page 325

Remove the snap ring [1], washer [2], and the seal
collar [3].
Coat a new O-ring [4] with engine oil and install it into
Ihe groove in Ihe collar.
Be careful not to
Inslali l he collar until it is seated.
damage the inner
Install the washer and the snap ring into the cover
surface of the col/ar.
groove properly.
Drive new bearings in with the marked side facing up.
TOOLS:
Crankshaft bearing (1) :
Driver (2J
Attachment, 42 x 47 mm [3]
Pilot, 17 mm (4)
Output shaft bearing [5) :
Driver
Attachment, 42 x 47 mm
Pilot, 25 mm
INSTALLATION
07749-0010000
07746-0010300
07746·0040400
07749·0010000
07746-0010300
07746·0040600
Clean the crankcase and cover mating surfaces.
Coat a new O-ring [1] with engine oil and install il into
the oil pipe jOint (2) groove.
Install the oil pipe joint and three bolts
[31
and tighten
the bolts.
Coat a new O-ring [4] with engine oil and install it into
the oil passage sealing cap [5] groove.
Install the sealing cap and tighten
it.
TORQUE : 18 N'm (1.8 kgf' m, 13lbfft)
Instalilhe following:
- sealing bolts
11]
with new washers [2]
- dip stick (3]
- oil filter (page 3-11)
DRIVETRAIN SYSTEM
131
16-37