Sub-Transmission - Honda SXS700M4 Service Manual

SUB-TRANSMISSION/GEARSHIFT LINKAGE
Install the ground cable [1J and tighten the boll
12J
by
aligning the terminal edge with the case rib as shown.
InslaUthe following:
- starter reduction gears (page 12-8)
- alternator cover (page 12-8)
- starter molor (page 6-4)
- gear position switch (page 16-54)
- EOT
sensor (page
16-55)
- rear propeller shaft (page 18-61)
- front propeller shaft (page 18-42)
- air cleaner housing (page 7-16)
- exhaust Pipe (page 2-30)
SUB-TRANSMISSION
DISASSEMBLY
Remove the following:
- rear crankcase cover (page 13-5)
- washer [1]
- idle gear [2J
- washer (3J
- gear shaft
(4)
- two needle bearings (5J
- shift fork shaft [11
- shift fork 121
- countershaft assembly 131
- output shaft [1J
- output driven gear [2]
13-9