Honda SXS700M4 Service Manual page 111

4. TP Sensor Input Line Open Circuit Inspection
Turn the ignition switch to OFF (0).
Disconnect the peM 33P (gray) (1) connector
(page
4~28) .
Check the wire for continuity between the wire
harness side 5P connecior [2J and 33P (gray)
connector terminals .
TOOL:
Test probe, 2 pack
07ZAJ-ROJA110
Connection : Brown/white (B3) - Brownlwhite
Is there continuity ?
YES - Replace the peM with a known good one
and recheck.
NO
- Open circuit in the Brown/white wire
5.
TP Sensor Output Line Open Circuit Ins pection
Turn the ignition switch to OFF (0).
Disconnect the PCM 33P (gray) [1 J connector
(page 4-28).
Check the wire for continuity between the wire
harness side 5P connector (1J and 33P (gray)
connector [2J terminals.
TOOL:
Test probe, 2 pack
07ZAJ·RDJA 110
Connection: Yellow/blue (B14) - Yellow/blue
Is there c ontinuity?
YES - GO TO STEP 6.
NO - Open circuli in the Yellow/b!ue wire
6. TP Sensor Output Line Short Circuit Inspection
PGM-FI SYSTEM
Brown/white (83)
c~Q
111
1\
}' 1
~
I '
-I
Q
I
YelloW(lue
Yellow/blue (814)
Check the wire for continuity between the wire
, - - - - - -- -------:-C----,
harness side 5P connector [1] terminal and ground. [1]
Is there continuity ?
YES - Short circuit in the Yellow/blue wire
NO - GO TO STEP 7.
7. TP Sensor Inspection
Replace the sensor unit (TP sensor) with a known
good one (page 4-25).
Connect the PCM 33P (gray) (1J connector
(page 4-28).
Erase the DTC (page 4-6).
Turn the ignition switch to ON (I).
Check the TP sensor with the MCS.
Is
OTe 8-1
indicated?
YES - Replace the PCM wi th a known good one
and recheck.
NO - Faulty original sensor unit (TP sensor)
Yellow/blue
4-15