Torque Converter - Honda SXS700M4 Service Manual

DRIVETRAIN SYSTEM
Align
the flange
labs
with Ihe grooves in
the collar.
Apply engine oil to the outer surface of feed pipe C [1
J.
Insert feed pipe C while turning it slowly to avoid
damaging the O-ring in the setting collar.
Coal a new O-ring [2J with engine oil and install it into
the oil feed pipe setting cap [3] groove.
Inslall the selling cap and tighten it.
TORQUE : 21 N' m (2.1 kgf·m,
151bHt)
Inslali lhe following:
- shift valve body (page 16-33)
- front propeller shaft (page 18-42)
- water pump (page 9-9)
- oil cooler (page 8-10)
- exhaust system (page 2-30)
TORQUE CONVERTER
REMOVAL
Remove the front crankcase cover (page 16-34).
Be
careful not to
Unstake the lock nul [1].
damage the
Loosen the lock nul while holding the converter boss
crankshaft threads.
with an open end wrench (width across flats: 32 mm).
16-40
Remove the lock nut and washer {2J.
Remove the torque converter assembly
[1
J
using the
;;;::::;:=;
special tools.
TOOL:
Puller, 35)( 1.0 mm [2J
Remove the following:
07933-HA80000 or
07933-HB3000A
(U .S.A . only)
- stator shaft
11]
(while tuming it counterclockwise)
- needle bearings [2J