Honda SXS700M4 Service Manual page 331

Apply engme oil to the two needle bearings (1] and
install them Into the stator shaft from both sides.
Apply engine oil to the needle bearing 12] and install it
onlo the stator shaft.
Install the stator shaft (1] onlo the crankshaft (2] and the
inner coliar
[3)
while turning
it
counterclockwise.
Install the torque converter [1] by aligning the splines
carefully, and engaging the primary drive and driven
gear teeth [2].
Inslallthe washer [3).
Apply engine oil to the threads of a new lock nut (1].
Install the lock nut and tighten
it
while holding the
converter boss with an open end wrench (width across
flats:
32
mm ).
TORQUE : 118 N'm (12.0 kgf' m, 87IbHt)
Be careful not
to Slake the lock nut into the crankshaft groove.
damage/he
crankshaft threads.
Install the front crankcase cover (page 16-37)
DRIVETRAIN SYSTEM
121
'D
16-43