Honda SXS700M4 Service Manual page 315

Blow through all the
oil
passages
thoroughly
(including sa/enoid
valves).
Air should not flow (the pressure should be maintained)
while the battery is connected, and should flow out of
the output ports that goes to the shift valve when the
battery is disconnected.
Connect the 12 V battery [1] positive terminal to the
AfT
clutch PC solenoid valve connector [2[ terminals and
check the spool valve through the oil passages for
operation.
DRIVETRAIN SYSTEM
OUTLET PORTS
INLET PORT
EB 8
121 111
The valve should move away from the solenoid side
~=================~
when the battery is connected , and should be returned
by spring force when the battery is disconnected.
SPOOL VALVE
Remove the following from the
AfT
clutch PC solenoid
~==================~
valve assembly:
- screw
(1]
and lock plate [2]
- valve stopper bolt
PI
- emergency valve [4J
- valve spring [5J
Wash atl the removed parts with a high flash point or
non-flammable solvent and blow dry them with
compressed air to clean completely.
Check the emergency valve and valve bore for scoring,
scratch or abnormal wear.
121
[31
16·27