Honda SXS700M4 Service Manual page 385

Install the shift fork (1) and align the groove with the lock
spring
[2]
end.
While holding the
Install the stopper plate [1J by aligning the flat surfaces
shift fork, push the
so the plate is attached onto the fork lug [21.
arm
shaft to slide il
inward and instali
Install the clutch spring [3] with the bent end [4) toward
the shift fork.
the shaft end into
the pivot hole in the
housing.
DRIVE SHAFT/FINAL GEAR
Tum the arm shaft [1] clockwise by holding the collar
[21
;"'''''======:' ' ' ' ' ' = .........
IIIIIIII="===~
with
a open
end wrench and align the arm tab with the
collar groove, then tap the shaft to
fit
them securely.
Align the bolt hole in the fork with the groove in the shaft
and install a new fork bolt
[3].
Tighten the fork bolt.
TORQUE: 10 N'm (1 .0 kgf'm, 7 IbHt)
Align
[1 [
18-23