Honda SXS700M4 Service Manual page 201

CYLINDER HEADIVALVEICAMSHAFT
SERVICE INFORMATION
GENERAL
This section covers service of the rocker arms, cylinder head, valves and camshaft. These services can be done wi th the engine
installed in Ihe frame.
When disassembling , mark and store the disassembled parts to ensure that they are reinstalled in their original locations.
Clean all disassembled parts with cleaning solvent and dry them by blowing them off with compressed air before inspection.
Rocker arm, valve and camshaft lubricating oil is fed through oil passages in the cylinder head and head cover. Clean the oil
passages before assembling cylinder head and head cover.
Be careful not to damage Ihe mating surfaces when removing the cylinder head cover and cylinder head.
TOOLS
Valve spring compressor
07757-0010000
Valve seat culler. 35 mm (45
0
IN/EX)
07780-0010400
or equivalent commercially available in
U.S.A.
Interior cutler, 34 mm (60° INfEX)
07780-0014700
or equivalent commerCially available in
U.S.A.
Valve guide driver, 5.5 mm
07742-0010100
Flat culler, 38.5 mm (32° IN)
07780-0012400
or equivalent commercially available in
U.S.A.
Cutter holder, 5.5 mm
07781-0010101
or equivalent commercially available in
U.S.A.
Valve guide reamer, 5.5 mm
07984-2000001
or 07984-2000000 (U.S.A. only)
Flat culler, 35 mm (32
0
EX)
07780-0012300
C~
or equivalent commercially available in
U.S.A.
T ensioner holder 8
070MG-0010100
or 07AMG-001A100 (U .S.A. only)
or 07AMG-MFJA100 (U .S.A. only)
10·3