Honda SXS700M4 Service Manual page 193

Loosen the three cover bolts (1] .
Remove the following:
- two mounting bolts [2]
- water pump assembly [3J
three cover boilS [1J and sealing washer (2J
- pump cover [3J
- O-rings [4J
- bleed hose [5J
- hose guide [6]
INSTALLATION
ISJ
Install the hose guide [1] onto the bleed hose [2J and
r-:-~
..
the hose onto the pump body [3J.
Coal a new O-ring (4) with engine oil and install it on the
stepped section of the pump body.
Install the water pump while turning the impeller to
engage the pump shafts.
Align the mounting bolt holes in the pump body and c.,, ___
~
crankcase cover, and be sure the water pump is fully r
seated.
Install a new O-ring [5] into the pump body groove
properly.
COOLING SYSTEM
9·9