Honda SXS700M4 Service Manual page 397

Cover the clutch
Install the special tools onto the pinion gear shaft and
housing mating
gear case , Using a heat gun, heat the case.
surface
with
aluminum shims or
TOOLS :
an equivalent to Pinion puller base [1]
prevent damaging
Puller shaft and nut (2)
il.
Threaded adaptor (3]
U.S.A. TOOLS:
Pinion puller base
Puller shaft
Special nut
Threaded adaptor
07HMC·MMS0110
07965·VM00200
070MF·HP50100
07HMC·MM8011A
07931·ME4010B
07931·HBJ020A
070MF·HP5A100
Pull the pinion assembly out from the gear case.
PINION BALL BEARING AND SHIM
REPLACEMENT
Take care notlo
Press the pinion gear [1J oul of the bearing.
contact the support
blocks agamst/he
gear/eeth.
Remove the pinion shim [2).
Replace the pinion joint needle bearing in the shaft end
if necessary
(page
18-36).
DRIVE SHAFT/FINAL GEAR
_ _ [21
131
Install the shim 111 and a new bearing [2J onto the pinion
~-----------------,
gear [3].
NOTE :
When the gear set, differential bearing, differential
and/or gear case has been replaced, use a 2.00 mm
(0.079 in) thick shim for initial reference .
Press the pinion gear [1J into the bearing until it is fully
:========::::;;;;;;~=======~
seated by supporting the bearing inner race.
TOOL:
Attachment, 30 mm 1.0. [2] 07746-0030300
18-35