Honda SXS700M4 Service Manual page 337

NOTE
The followmg procedures are for the 1 SI dutch. The
procedures for the 2nd and 3rd clutches are the
same as for the 1st clutch.
Clean the inner surface of the clutch drum [11
thoroughly and blow through the oil holes in the drum
boss and check valve in the piston [21 .
Apply engine oil 10 new O-rings [3] and install them into
the piston grooves.
Place the clutch piston into the clutch drum with the flat
side facing in.
DRIVETRAIN SYSTEM
13J g ' l
Becarefufnotto
Install the piston 111 while turning it to ensure proper
~============;::===;:::=~
pinch the ()..rings
seating .
with too much
force.
Place the return spring 11). spring retainer [2] and snap
ring [3] mto the
clutch drum.
Instalilhe special tools (4J while adJustmg their position
carefully (page 16-46).
To prevent loss
of Compress the return spring by tightening the nut.
spnng tension. do
not compress more
than necessary.
AJign
the
end
gap
with the
groove
(3
pJaces) in the
spring retainer.
Install the snap ring
I1j
into the groove in the drum boss
properly.
Loosen the nut and remove the special tools .
131
[1[
12J
11J
16-49