Honda SXS700M4 Service Manual page 406

DRIVE SHAFT/FINAL GEAR
Install the holder bracket [1] and cover base (21 wilh
the
two bolts [3], and tighten them .
TORQUE : 10 N' m (1.0 kgf' m, 7 lbHt)
Sellhe drive mode selector lever
10
the 2WD position.
tnstali lhe spring [11 onlo Ihe selector cable ]2],
Insert the cable into the cable holder [3] and connect it
to the clu tch arm with the joint pin [4] and adjusting nul
[51.
Set the groove in the cable grommet [6J onto the cover
base end proper1y.
Install the retaining plate [71 onto the cable with the
concave facing the cable holder to secure the cable.
Operate the differenliallQck arm to the upper side to set
:;;==;;;;;;;;=~;:;;;;;;;;;;;;;;;;;;;
it to the lock free position.
Connect the differential lock cable to the lock arm
11]
and install it into the cable holder [2] by aligning the flat
surfaces.
Install the washer [3] and a new cotter pin [4] .
Make sura that the
Screw the cable nuts [5] together gradually (to move
dnWJ mode selector
both nuts to the cable holder side) by your hands so
lever
is
2WD
that the cable is not forced until they are touched to the
position
and the
cable holder.
differential lock ann
Tighten the cable nut while holding the other nut.
is Jock
free (upper)
position
18-44
Connect the breather hose [1] and the differential Jock
switch connector (2].
1