Honda SXS700M4 Service Manual page 204

CYLINDER HEADNALVE/CAMSHAFT
Set the piston position to Top Dead Center on the
compression stroke (page 3-8).
Remove the following:
- seven bolts [1J and three washers [2]
- four cap nuts (3] and washers [4)
- cylinder head cover (5)
Mark
1M
push rods
-
push rods [1]
so they can be -
gasket [21
placed back in their -
dowel pins [3)
original locations.
- cam followers [11
DISASSEMBLY
Remove the two bolts [1] and sealing washers [2\.
Push the rocker arm shaft [3] wi th the small screwdriver
through the bolt hole until the O-ring on the shaft is
~
...
I"Il'-.... ,
removed out of the head cover.
10·6