Honda SXS700M4 Service Manual page 258

SUB·TRANSMISSION/GEARSHIFT LINKAGE
13·14
Apply locking agent to the pivot bolt [1] threads.
Install the spring (2] , washer [3) (between the crankcase
and arm) and stopper arm [4) wi th the bolt as shown
and tighten the bolt.
TORQUE : 12 N' m (1.2 kgf' m, 9lbHt)
Install the snap ring [1] inlo the spindle groove with the
!~~~~~~~~~;;:~:~!!~!
chamfered edge facing the crankcase cover side
Install the shifter gear [2J with the index line (3J facing
the snap ring, aligning the wide groove wi th the wide
tooth.
Install the gearshift spindle (4J and rest It onto the
stopper (5J on the crankcase.
Install the washer [6] onto the spindle.
Apply engine oil to the shift drum (1] guide groove
lift the stopper arm [2J and install the shift drum so the
index line [3J on the spindle shifter gear is aligned
between the punch marks [4].
Turn the shift drum clockwise and set It in neutral
position so its groove poSition is vertical.
Apply grease to the lips of a new oil seal
[11.
and Install
it into the front crankcase cover until fully seated.
j
I
j
•
•
I
1
I
I
I