Table of Contents
Advertisement
ENG)NE REMOVAU[NSTALLAT[ON
Apply 5
-
8 g of molybdenum disulfide grease to the
pinion ;oint (1)
splines.
Place the boot band (2) over the front propeller shaft [3]
temporarily.
Install the propeller shaft into the pinion
joint,
aligning
the
splines until the stopper ring [4J seats in
the
groove.
Make sure
the
stopper
ring
is seated properly by pulling
the propeller shaft
lightly.
Install the boot [5J over the pinion jOint and propeller
shaft grooves securely and the boot band into the boot
groove.
Coat a new O-ring [6) with molybdenum disulfide
grease and install it
into
the output shaft
groove.
Apply molybdenum disulfide grease to the propeller
shaft joint
[71
splines.
Move the fron
t
final gear case forward
for
maximum
clearance between the shaft joint and output
shaft.
Engage the shaft jOint over the output shaft and move
the front final gear case rearward.
The mountmg bolt
Align
the
upper mounting
boll
holes in the front final
~r~;;;;
is
Installad
from the
gear case and frame, then install the
front
final gear
/eft
side.
case upper mounting bolt [1) and a new mounting nut
15·10
[2).
Install the two front final gear case mounting bracket
bolts [3) and tighten them.
Tighten
the
final gear case mounting nuts.
TORQUE
:
12 mm
nut:
54
N'
m
(5.5
kgf·m.
40 IbHt)
Position the main wire harness (1) as
shown,
then
~K;~~~;:;:.r;;~~;;
••••
I;"~
install
the three harness clips [2) into the
frame.
j
I
•
i
j
j
J
Advertisement
Table of Contents
Troubleshooting
