Honda SXS700M4 Service Manual page 167

FUEL SYSTEM
NOTE :
Do not loosen or tighten the white painted screws [1) , - - - - - - - - -- - - -
l
and nut [2] .
IACV removal/installation (page 7-23)
Fuel injector removallinslallation (page 7-24)
TP sensor/MAP sensor (sensor unit) replacement
(page 4-25)
INSTALLA nON
[11
Align the hole of the insulator band [1] with the boss of
r-I'~-;a;:;IJ'IIT---::--i"liJ;7-!iI!Ji
the insulator [2J .
Install the insulator onto the cylinder head by aligning
the groove with the lug.
Align the hole of the insulator band [1] with the boss of
the insulator [2).
Install the throttle body (3) into the insulator by aligning
the lug with the groove .
Tighten both insulator band screws so that the distance
between the band tabs is as shown.
12
± 1 mm
(0.47
±
0.04 in)
j
7-21