Honda SXS700M4 Service Manual page 443

BEARING REPLACEMENT
Remove the snap ring [1].
Press the bearing [2) out of the knuckle using a suitable
collar.
Carefully press a new bearing in the knuckle with the
marking side facing up until it is fully seated .
TOOLS :
Driver [3]
A"achment, 62 x 64 mm [4)
07749-0010000
07947-6340400
or
07AMD-H L1A100
(U.S.A. only)
Inslall the snap ring into the knuckle groove with the
chamfered side facing in.
INSTALLATION
WHEEL/SUSPENSION
Install the inner seal
Coat the lips of new inner dust seal (1) and Quter dust
r-------~
first, then install /he
seal [2] with grease and install each dust seal until
it
is
outer seal.
flush with the knuckle, being careful nollo damage the
lip.
TOOLS :
Driver (3] 07749-0010000
Oil seal driver aHachment (4) 07947-6340201 or
07AMO-Hl1A100
(U.S.A. only)
Pack the lip cavities of the each dust seal with 2 .5 - 3 g
of grease.
19-13