Honda SXS700M4 Service Manual page 239

The
cover
(stator)
is
magnellcally
attracted
10
the
flywheel. be careful
not
10
gel anything
caugh/between
these parts when
Installing
Carefully install the alternator cover (1J.
Inslall the len bolts 12) with four new sealing washers [3]
and the
clip
stay [4], and tighten them in a crisscross
pattern in several steps.
NOTE'
The location for the bolt With sealing washer is
indicated with triangle marks on the cover.
Inslall the gear selector arm
[1J
by aligning the slit with
the index hne of the spindle.
Install the pinch bolt [2J and tighten
it
to the specified
torque .
TORQUE: 16 N'm (1 .6 kgf'm , 12 IbHt)
Install the cable holder
11]
with the two bolts [2).
Installlhe wire band 111 into the cable holder.
Connect the EDT sensor 2P connector (2].
AL TERNATORISTARTER CLUTCH
12-9