Honda SXS700M4 Service Manual page 252

SUB-TRANSMISSION/GEARSHIFT LINKAGE
Install the two dowel pins (1] and a new gasket (2] .
Make sure that the reverse idle shaft washer [3] and
gearshift spindle washer [4] are installed, and thai the
shift drum position is neutral as shown (switch pin
groove
[5]
is in vertical position).
Install a new sealing washer [11 onto the drain bolt [21.
Coal a new O-ring [3J with engine oil and install it into
the drain bolt groove.
Install the rear crankcase cover [4] with the following
fasteners:
- eleven 6 mm bolts [5)
- two
8
mm bolts [6)
- oil drain
bolt
Tighten the bolts in a crisscross pattern in severa!
steps.
TORQUE: Drain bolt: 25 N-m (2.5 kgf'm, 18 IbHt)
l ower the engine and maneuver
it
into place.
HoIdtMengme
Insert the engine side mounllng bolts (1J from the front
secure/yandtake
side.
care not
to damage
Install the engine side mounling nuts
[2]
and tighten
the frame and
them.
engine.
13-8
TORQUE : 54 N' m (5.5 kgf' m, 40
IbUt)
Coat a new O-ring [1] with engine oil and install it onto
the oil filler pipe [2].
Install the filler pipe with the two bolts {3].
J
I
l
,
j
t
I
I
l
1
,
•
I
j
!