Honda SXS700M4 Service Manual page 359

Wrap vinyl tape around the pinion splines and groove ,
and coat it wilh grease 10 avoid damaging the dust seal
lip.
Apply
0.2
g minimum of grease to a new dust seal [1]
lips. Install the dust sea) with the flat side facing up until
it is fully seated.
TOOLS :
Driver,
22
mm
1 .0 . [2]
Base collar (3)
Remove the tape.
07746-0020100
07GAJ·PG20120
Pack 2 g minimum of grease in between the dust seal
and dust cover [1] (shadowed area).
Be sure the dust
Install the dust cover and fit it into the pinion groove [2].
cover does not
contact fhe gear box
housing
{3].
Apply
0.2 - 0.5
g of grease to the sliding surface (rack
side) of the rack guide [1[.
Apply sealant (Threebond TB1102 or equivalent) to the
3 threads of the rack guide screw [2J .
Instali l he following:
rack guide
- cone washer [3] (with the concave side facing out)
- pressure spring [4J
- rack guide screw
- lock nut [5J
Perform the rack guide adjustment (page 3-21).
Check the rack and pinion for smooth movement.
STEERING SYSTEM
{21
n/
21
I n l
{3{
PI
131
17-15