Honda SXS700M4 Service Manual page 310

DRIVETRAIN SYSTEM
2. Gear Position Switch Inspection at peM
Connector
Turn the ignition switch to OFF (0) .
Disconnect the
peM
33P (black) connector (11
(page 4-28).
Check for continui ty between the wire harness side
33P (black) connector terminals and ground .
There should be continuity in each gear position ,
and no continuity in the olher position .
ear pas t on
rive
eutra
everse
TOOL:
onnec or termma
19 t
ue Ite
reen ue
cay
Test probe , 2 pack 07ZAJ·RDJA110
Are the test results normal?
YES - GO TO STEP 4 .
NO - GO TO STEP 3.
3. Gear Position Switch Inspection at Switch
Connector
11]
Gray (A25) Light blue/white (A13 )
.=¥Q
Green/blue
(A17 )
Disconnect the gear position switch 3P (black) , - - - - - - - - - - - - - -- - -,
16·22
connector
[11
(page
16-54).
Check for continuity between Ihe switch side 3P
connector terminals and ground .
There should be continuity in each gear position ,
and no continuity in the other position .
ear POSI Ion onnector ermma
rive
eutra
everse
Igt ue Ie
Ig t green
cay
Are the test results normal?
YES - Open or short circuit in the light bluel
white wire.
Open or short circuit in the Green/blue
wire.
Open or short circuit in the Gray wire .
NO - Faulty gear position switch.
4. Failure Reproduction
Connect the PCM 33P (black) connector and gear
pOSition switch 3P (black) connector.
Erase the DTC (page 4-8).
Test-drive the vehicle and stop the engine.
Recheck the DTC with the MCS.
Is Dre 41-1 indicated?
YES - Replace the PCM wi th a known good one
and recheck.
NO - Intermittent failure .
11]
light blue/white Gcay
light green
1