Wheels; Tires - Honda SXS700M4 Service Manual

WHEEUSUSPENSION
WHEELS
TIRES
REMOVAL
loosen the
wheel
nuts (lJ.
Raise the wheels off the ground.
Remove the nuts and wheel.
INSTALLATION
Clean the mating surfaces of Ihe wheel and hub
thoroughly.
Install the wheel and the nuts with the tapered side
facing inward, and lighten them.
TORQUE : 133 N'm (13.6 kgf'm, 98 Ibf·ft)
REMOVAL
NOTE:
This service requires the A TV Bead Busler
(KLS379024).
Remove and inslall the tire from the rim side
opposite Ihe valve stem.
Remove the core from Ihe valve slem.
Use a pneumatic tire changer or equivalent to remove
the tife from the rim. If a tire changer is not available,
rim protectors and tire irons may
be
used.
Adjust the bottom rim supports
PI
to the proper rim
size. Align the flat side of the support with the
corresponding rim size indicator.
US90nlywarerasa
Lube the bead area of the tire with wa ter, pressing
lubncanr when
down on the tire sidewalVbead area in several places to
remoVing
01'
allow the water to run into and around the bead .
mounting
tires.
Soap
or
soma
mountmg IlIbrlcanrs
maylealla
a
sJippery
residue
whK:h
can
calise the tIrO
to
shift on the nm and
lose tire pressure
during drilling.
19·6
Place the wheel assembly over the center shaft [1J and
use the correct size cone [2] to keep the wheel centered
during operation.
tnstall the bottom hold down nut [3]. bearing side down.
and finger tighten it so the wheel can rotate freely
during operation.
111
00
11~
13J
I
""