Honda SXS700M4 Service Manual page 452

WHEEUSUSPENSION
BEARING REPLACEMENT
Remove the snap ring {1J .
Press the bearing [2] out of the knuckle using a suitable
collar.
Carefully press a new bearing in the knuckle with the
marking side facing up until
it
is fully sealed.
TOOLS:
Driver [3J
Atta c hment , 72 x 75 mm [41
07749-0010000
07746-0010600
Install the snap ring into the knuckle groove with the
chamfered edge facing in.
INSTALLATION
Apply molybdenum disulfide grease to the drive shaft
splines.
Install the knuckle (1) to the upper and lower arms with
its
~UP·
mark (2] facing up as shown.
/nserrtheOOlls from
Install the pivot bolts 13] and new nuls (4] . then tighten
the rearside.
them to the specified torque.
19·22
TORQUE: 44 N'm (4.5 kgf'm , 32 IbHt)
Apply 5 mm (0.2 in) bead of sealant (Threebond TB
1215
or
loclile LT5699 or equivalent) to the innermost
threads of the drive shaft (hub nut mounting area).
Install the wheel hub (11 to the knuckle and drive shaft.
Inslall the hub nut {2] and tighten it to the specified
torque, then further lighten until its grooves align with
the coller pin hole.
TORQUE : 137 N'm (14.0 kgf' m , 1011bHt)
Install a new cotter pin {3J.
Install the following:
- rear shock absorber (page 19-27)
- rear wheel (page 19-6)
12J
{11