Punch Horizontal Position Adjustment - Oce CS250 User Manual

Utility mode
– Each time [+] or [-] is touched, the value is increased or
decreased by one increment.
– If the punch positions are too far blow the center of the
paper, touch [-] under "Adjust Value" to increase the
adjustment (between -0.1 mm and -5.0 mm).
8
Touch [OK].
– To cancel the setting and select the default, press the [Reset] key.
The vertical position of the punched holes is adjusted.
If no adjustment of the vertical position of the punched holes was necessary in step 7, this completes
the procedure.
9
Use a Punch setting to print another sample copy.
10
Check the print result.
– Check that the vertical position of the punched holes was adjusted.
– If more adjustment is necessary, repeat steps 6 through 9.

Punch horizontal position adjustment

The horizontal position of punched holes when printing with a Punch setting can be adjusted for each paper
size.
Note
For details on the Punch settings, refer to "Punching holes in copies ("Punch" settings)" on page 4-69.
The adjustment range differs depending on the finisher that is installed.
0 Before making any adjustments, use a Punch setting to print a sample copy. Perform the adjustment
while checking the sample that was created.
1
Display the Administrator Settings screen.
– For details on displaying the Administrator Settings screen, refer to "Displaying the administrator
settings screen" on page 13-37.
2
Touch [1 System Settings].
The System Settings screen appears.
3
Touch [7 Expert Adjustment].
The Expert Adjustment screen appears.
4
Touch [3 Finisher Adjustment].
The Finisher Adjustment screen appears.
CS250/CS240/CS231
13
13-55