Deleting A Copy Program - Oce CS250 User Manual

Additional copy operations
? Can the specified settings for a copy program be checked?
% To check the programmed copy settings, touch the button for the desired copy program, and then
touch [Check Program Settings]. For details, refer to "Copying with programmed copy settings
(Mode Memory)" on page 5-12.
6
Touch [OK] or [Cancel].
– To return to the Basic screen, press the [Mode Memory] key.
!
Detail
To stop registering the program, press the [Reset] key or the [Mode Memory] key.
No matter which screen is displayed, the registration is cancelled.
Otherwise, continue to touch [Cancel] until the Basic screen is displayed.
The settings of a copy program cannot be changed.
If the copy program that was selected has been locked, [Edit Name] and [Delete] do not appear. For
details, refer to "System settings" on page 13-23.

Deleting a copy program

1
In the Recall Copy Program screen, touch the button for the copy program to be deleted.
– If the copy program to be recalled is not displayed, touch
program is displayed.
2
Touch [Delete].
A message appears, requesting confirmation to delete the copy program.
3
Touch [Yes], and then touch [OK].
The Recall Copy Program screen appears again. The copy settings registered in the copy program are
erased.
CS250/CS240/CS231
and until the desired copy
5
5-11