Additional copy operations
Setting the "Key Repeat Start/Interval Time" functions
The length of time until the value begins to change after a touch panel button is held down and the length of
time for the value to change to the next number can be specified.
0
The settings specified for the Key Repeat Start/Interval Time functions are only applied in the Enlarge
Display mode.
1
Display the Accessibility Setting screen.
–
For details on displaying the Accessibility Setting screen, refer to "Displaying the accessibility
setting screen" on page 5-19.
2
Touch [Key Repeat Start/Interval Time] or press the [2] key in the keypad.
The Key Repeat Start/Interval Time screen appears.
3
Touch [+] and [-] to specify the starting time and the interval for the key repeat feature.
–
To extend the time, touch [+].
–
To reduce the time, touch [-].
–
Both settings can be set between 0.1 and 3.0 seconds in 0.1-second increments.
–
To cancel changes to the settings, press the [Reset] key.
4
Touch [OK].
The Accessibility Setting screen appears again.
CS250/CS240/CS231
5
5-21