13
13.7
Printer adjustment
Leading edge adjustment
The starting print position at the leading edge of each type of paper (with respect to the paper feed direction)
can be adjusted.
0
The starting print position is adjusted during manufacturing of the machine. Normally, the starting print
position will not need to be adjusted.
1
Display the Administrator Settings screen.
–
For details on displaying the Administrator Settings screen, refer to "Displaying the administrator
settings screen" on page 13-37.
2
Touch [1 System Settings].
The System Settings screen appears.
3
Touch [7 Expert Adjustment].
The Expert Adjustment screen appears.
4
Touch [2 Printer Adjustment].
The Printer Adjustment screen appears.
5
Touch [1 Leading Edge Adjustment].
The Leading Edge Adjustment screen appears.
6
Touch the button for the paper type to be set.
7
Press the [Start] key.
–
Only paper loaded into the bypass tray can be used.
A test pattern is printed.
8
Check that the distance from the starting print position of the test pattern to the edge of the paper (a)
is 4.2 mm.
–
If the distance is less than 4.2 mm, touch [+] to increase the adjustment (between 0.2 mm and 3.0
mm).
–
If the distance is more than 4.2 mm, touch [-] to reduce the adjustment (between -0.2 mm and -3.0
mm).
–
Each time [+] or [-] is touched, the value is increased or decreased by one increment.
9
Press the [Start] key.
The adjusted test pattern is printed.
13-42
Utility mode
CS250/CS240/CS231