Oce CS250 User Manual page 417

Application functions
– If desired, touch [Chapter], and then use the keypad to type in the chapter number. The entered
chapter number is printed if "1-1, 1-2...." is selected under "Page Number Type".
– The setting for "Page Number" can be set to a number between –99999 and 99999, and the setting
for "Chapter" can be set to a number between –100 and 100.
– When specifying a setting for "Starting Page Number", switch the number between positive and
negative by pressing the [ ] key.
– If a negative value is specified, the numbers are not printed until the numbering reaches 1. For
example, if "–1" was specified, the numbers are printed starting with "1" on the third copied page.
– To cancel the "Page Number" function, touch [No].
5
Select a setting under "Page Number Type".
6
Touch [Print Position], and then select the printing position.
– To make fine adjustments to the printing position, touch [Adjust Position]. Select the desired
direction under "Left & Right Adjustment" or "Top & Bottom Adjustment", use the keypad or touch
[–] and [+] to specify the adjustment setting, and then touch [OK].
What are the limits on the adjustment amount?
?
% The print position can be finely adjusted in 0.1 mm increments.
Can no adjustment be made?
?
% To make no left/right or up/down adjustments, touch [No Adjustment].
? What happens when a value outside of the allowable range is specified?
% The message "Input error" appears. If "Input error" appears or if the adjustment value was
incorrectly entered, touch [No Adjustment] or press the [C] (clear) key, and then specify the correct
value.
CS250/CS240/CS231
9
9-81