Centering - Oce CS250 User Manual

Utility mode
10
Check the distance from the starting print position of the test
pattern to the edge of the paper.
– Check that the width has been adjusted to 4.2 mm.
– If more adjustment is necessary, repeat steps 8 and 9.
– To adjust the print position for a different type of paper,
return to step 6.
11
Touch [OK].
– To cancel the setting and select the default, press the [Reset] key.
The print position is adjusted.

Centering

The starting print position at the left edge of the paper (with respect to the paper feed direction) for each paper
tray can be adjusted.
0 The starting print position is adjusted during manufacturing of the machine. Normally, the starting print
position will not need to be adjusted.
0 Only A4 v paper can be used to adjust the bypass tray.
1
Display the Administrator Settings screen.
– For details on displaying the Administrator Settings screen, refer to "Displaying the administrator
settings screen" on page 13-37.
2
Touch [1 System Settings].
The System Settings screen appears.
3
Touch [7 Expert Adjustment].
The Expert Adjustment screen appears.
4
Touch [2 Printer Adjustment].
The Printer Adjustment screen appears.
5
Touch [2 Centering].
The Centering screen appears.
6
Touch the button for the paper tray to be set.
7
Press the [Start] key.
– Only paper loaded into the bypass tray can be used.
A test pattern is printed.
CS250/CS240/CS231
a: 4.2 mm
13
a
13-43