4
–
If the "Separate Scan Output Method" parameter is set to "Batch Print", touch [Finish] in the
following screen, which appears while the document is scanned with the ADF, to continue to step 5.
–
Load the next batch of the document, and then press the [Start] key.
–
Repeat step 2 until all document pages have been scanned.
–
If the document cannot be loaded into the ADF, place it on the original glass. For details on the types
of documents that can be loaded into the ADF, refer to "Original documents" on page 8-23.
–
To change the scanning settings, touch [Change Setting]. For details on changing the scanning
settings, refer to "Changing scan settings for each document" on page 4-28.
–
The buttons that appear in the screen for changing the settings differ depending on the specified
settings. Settings for the following can be changed.
1-Sided/2-Sided, Binding Position, Zoom, Frame Erase, Center Erase Original Size
–
To cancel changes to the settings, touch [Cancel].
–
The amount of memory available can be checked beside "Memory" in the lower-left corner of the
screen.
To delete the image data, press the [Stop] key, and then delete the job. For details, refer to
"Temporarily stopping scanning/printing" on page 4-86.
4
After all document pages have been scanned, touch [Finish].
4-12
Basic copy operations
CS250/CS240/CS231