Utility mode
13.8
Finisher adjustment
2-position staple pitch adjustment
The distance between staples when printing with the "2 Position" Staple setting ("Staple" and "Center Staple
& Fold") can be adjusted.
Note
[2-Position Staple Pitch Adjustment] appears only if optional finisher FS-608 is installed.
0
Before making any adjustments, use the "2 Position" Staple setting to print a sample copy. Perform the
adjustment while checking the sample that was created.
1
Display the Administrator Settings screen.
–
For details on displaying the Administrator Settings screen, refer to "Displaying the administrator
settings screen" on page 13-37.
2
Touch [1 System Settings].
The System Settings screen appears.
3
Touch [7 Expert Adjustment].
The Expert Adjustment screen appears.
4
Touch [3 Finisher Adjustment].
The Finisher Adjustment screen appears.
5
Touch [1 2-Position Staple Pitch Adjustment].
The Adjust Spacing of 2 Staples screen appears.
6
Touch the button for the setting to be adjusted.
7
Check the stapling positions in the sample copy.
–
Touch [+] or [-] under "Adjust Value" to adjust the distance (between 128 and 160 mm) between the
staples.
–
Each time [+] or [-] is touched, the value is increased or decreased by one increment.
8
Touch [OK].
The distance between the staples is adjusted.
If no adjustment of the distance between the staples was necessary in step 7, this completes the
procedure.
9
Use the "2 Position" Staple setting to print another sample copy.
10
Check the print result.
–
Check that the distance between the staples was adjusted.
–
If more adjustment is necessary, repeat steps 6 through 9.
CS250/CS240/CS231
13
13-47