Chapter 2 Overview Of The Configuration Commands; Network Settings (Net Mode) Configuration Commands - NETGEAR ProSafe SRX5308 Cli Reference Manual

Overview of the Configuration
2.
Commands
This chapter provides an overview of all configuration commands in the four configuration
command modes. The keywords and associated parameters that are available for these
commands are explained in the following chapters. The chapter includes the following sections:
•

Network Settings (Net Mode) Configuration Commands

• Security Settings (Security Mode) Configuration Commands
• Administrative and Monitoring Settings (System Mode) Configuration Commands
• VPN Settings (VPN Mode) Configuration Commands
Network Settings (Net Mode) Configuration Commands
Enter the net ? command at the CLI prompt to display the submodes in the net mode. The
following table lists the submodes and their commands in alphabetical order:
Table 7. Net mode configuration commands
Submode
ddns
dmz
ethernet
ipv6
ipv6_tunnel
Command Name
net ddns configure
net dmz ipv4 configure
net dmz ipv6 configure
net dmz ipv6 pool configure <ipv6 address>
net dmz pool ipv6 delete < ipv6 address>
net ethernet configure <interface name or
number>
net ipv6 ipmode configure
net ipv6_tunnel isatap add
net ipv6_tunnel isatap delete <row id>
Purpose
Enable, configure, or disable DDNS service.
Enable, configure, or disable the IPv4 DMZ.
Enable, configure, or disable the IPv6 DMZ.
Configure a new or existing IPv6 DMZ DHCP
address pool.
Delete an IPv6 DMZ DHCP address pool.
Configure a VLAN for a LAN interface.
Configure the IP mode (IPv4 only or
IPv4/IPv6).
Configure a new IPv6 ISATAP tunnel.
Delete an IPv6 ISATAP tunnel.
17
2