Using The Command Line Interface - NETGEAR FVS336Gv1 - ProSafe Dual WAN Gigabit Firewall Reference Manual

ProSafe Dual WAN Gigabit Firewall with SSL & IPsec VPN FVS336G Reference Manual
Note: The first time you remotely connect to the VPN firewall with a browser via SSL,
you may get a warning message regarding the SSL certificate. If you are using a
Windows computer with Internet Explorer 5.5 or higher, simply click Yes to accept
the certificate.
Note: If you are unable to remotely connect to the VPN firewall after enabling HTTPS
remote management, check whether other user policies, such as the default user
policy, are preventing access.
Note: If you disable HTTPS remote management, all SSL VPN user connections will
also be disabled.
Tip: If you are using a dynamic DNS service such as TZO, you can identify the WAN IP
address of your VPN firewall by running
option. Trace the route to your registered FQDN. For example, enter
FVS336G.mynetgear.net,
VPN firewall is displayed.

Using the Command Line Interface

You can access the command line interface (CLI) using Telnet from the LAN or, if enabled on the
Remote Management screen, from the WAN.
To access the CLI from a communications terminal when the VPN firewall is still set to its factory
defaults (or use your own settings if you have changed them), do the following:
1. From your computer's command line prompt, enter the following command:
telnet 192.168.1.1
2. Enter admin and password when prompted for the login and password information (or enter
guest and password to log in as a read-only guest).
3. Enter exit to end the CLI session.
Any configuration changes made via the CLI are not preserved after a reboot or power cycle unless
the user issues the CLI save command after making the changes.
8-12
tracert
and the WAN IP address that your ISP assigned to the
VPN Firewall and Network Management
v1.0, January 2010
from the Windows Run menu
tracert