Fax Option Type 1045 Installation - Gestetner B003 Service Manual

1.1.3 FAX OPTION TYPE 1045 INSTALLATION

[B]
[A]
!
CAUTION
Before installing this option, do the following:
1. If there is a printer option in the machine, print out all data in the printer
buffer.
2. Press the operation switch to enter standby mode. Make sure the power
LED is not lit, then turn off the main switch and disconnect the power
cord and the network cable.
1. Remove the small cover [A] (1 screw) and connector [B].
2. Remove the left rear cover [C] (2 screws), the rear upper cover [D] (2 screws)
and the rear lower cover [E] (4 screws).
3. Attach the NCU unit [F] to the machine (2 screws).
NOTE: If any G3 Interface Unit Type 1045 has to been installed, attach the
additional NCU boards to the NCU unit before attaching the NCU unit
to the machine. Refer to the Installation Procedure for the G3 Interface
Unit Type 1045.
SM
B360I101.WMF
[E]
[F]
1-3
[D]
B360I103.WMF
B003/B004/B006/B007
FAX UNIT
[C]
B360I102.WMF