Tray Shifting; Tray Shift Mechanisms - Gestetner B003 Service Manual

TRAY SHIFTING

4.4 TRAY SHIFTING

4.4.1 TRAY SHIFT MECHANISMS

[F]
[A] [B]
[C]
[D]
[E]
B352D106.WMF
Tray 1 (Upper Tray)
In sort/stack mode, tray 1 [A] moves from side to side to separate the printed sets.
The tray 1 shift motor [B], inside the shift tray, controls the horizontal position of
tray 1 through the timing belt [C] and gear disk [D].
After one print set is delivered to tray 1, the shift motor turns on, driving the gear
disk and the arm [E], and the tray drive unit moves to one side.
Two shift sensors [F] detect when to stop this side-to-side movement. There is a
cut-out in the gear disk. The shift tray moves in one direction until one of the shift
sensors detects the cut-out. Then the shift tray stops.
The next set of prints is then delivered, and the gear disk is turned in the opposite
direction until the other shift sensor is activated.
SM 14-21 B003/B004/B006/B007